Intra-articular Fracture Diagnosis
Intra-articular Fracture Diagnosis
Confirming an intra-articular fracture takes two steps, and they answer different questions. Radiographs in two planes establish that a fracture exists and whether it enters the joint. Computed tomography then shows what the joint surface actually looks like — how many articular fragments there are, where the surface is depressed, and which way the fracture lines run — and it is the image the reduction is planned from. Alongside both, the soft tissues over the joint are examined at every review, because the state of the skin decides the day of the operation rather than the calendar. And the assessment looks beyond the bone at the circulation, the nerves and, where the findings raise it, the compartment pressures, because those are the findings that change an operation from planned to immediate.
The first images, and what they can and cannot say
Imaging starts with plain radiographs of the injured joint, and the standard is at least two views at right angles to each other. This is not redundancy: a joint surface displaced in one plane can look undisplaced in another, and a single view is the commonest reason a fracture is under-called.
What the radiographs establish is the part that matters at the bedside: that there is a fracture, that it reaches the articular surface, how far the fragments have moved, and whether the joint is aligned or subluxated. They also show the things that accompany these fractures and change the plan — an avulsed fragment that turns out to be a ligament pulling a piece of bone off, a second fracture further up the same bone, or a joint above or below that is also injured. Where the mechanism suggests it, the joints above and below are imaged too, because a force that breaks one joint often injures another.
What radiographs cannot do is show the articular surface itself. This is worth being blunt about, because it is the single most important limitation in this injury and it is not widely understood. A joint surface is a curved or angled three-dimensional structure, and on a flat film the fragments overlap each other. A segment that has been driven downwards into the bone below — the classic depression of a tibial plateau — may produce only a subtle change in the density of the bone on a radiograph, and can be measured with confidence only on a cross-sectional image. The same applies to a fragment that has rotated rather than shifted: it looks undisplaced from the front and is not.
So the radiograph answers the question the patient asks — is it broken? — and leaves the question the surgeon asks — what does the surface look like? — to the next image. A joint fracture that is assessed on radiographs alone is planned from an incomplete picture, and the plan can change materially once the CT is reviewed.
CT: the image the operation is planned from
In an intra-articular fracture, computed tomography with reconstructions is not a refinement of the radiograph. It is the principal planning image, and in most centres it is obtained before the operation rather than during it.
What it adds is the part the radiograph cannot show. The number of separate articular fragments, which is often more than the radiograph suggests. Whether a segment is depressed into the bone beneath it and by how much, which decides whether it has to be lifted and what has to be put underneath it to hold it up. The direction the fracture lines run, which decides the surgical approach and the order in which the fragments are reduced. And whether the fracture extends into the shaft, which changes the implant from a fragment-specific one to a longer construct.
The practical consequence is that the operation becomes a planned procedure rather than an exploration. The approach, the position of the patient, the implants needed, the order of reduction and the expected difficulties are all worked out from the images beforehand. This shortens the operation, reduces the amount of soft-tissue dissection needed to work out what is going on, and — because a depressed segment can be identified in advance — makes it much less likely that a part of the joint surface is left untouched. Surgeons describe this as knowing the fracture before opening it, and it is the standard in these injuries rather than an extra.
There is one thing CT does not do, and confusing the two is a common source of disappointment. CT shows bone in exquisite detail and shows cartilage hardly at all. It will not tell you whether the cartilage surface is still intact over a fragment, whether a meniscus is torn, or whether a ligament has been avulsed. Those are assessed at the time of surgery, directly or with an arthroscope, and on MRI beforehand where the question needs answering in advance.
What the radiograph misses, and how it is found
Three categories of finding are missed on plain films often enough to be worth naming, because in each the missed finding changes the treatment rather than merely completing the record.
The first is the undisplaced articular fracture. A crack that runs into the joint without separating leaves no gap for a radiograph to show, particularly in bone that is osteoporotic and therefore less dense to begin with. It is found because the findings do not match the film: a joint that is swollen, tender on the joint line and unwilling to take weight. MRI is the most sensitive test for it, showing the bruising inside the bone; CT shows it as a line once the suspicion exists. The reason it matters is that an undisplaced articular fracture is stable only while it stays that way, and missing it means a patient walks on a joint surface that is cracked.
The second is the depressed segment already described — a piece of the surface driven into the bone below rather than displaced sideways. It is the pattern most characteristic of a tibial plateau fracture and the one most often under-appreciated on the radiograph. It is found on CT, and it is the finding that most often changes a plan from non-operative to operative.
The third is the injury next to the fracture. A meniscus torn at the same moment, a ligament avulsed with its fragment of bone, the second fracture in the same bone or in the joint above, and the injury to the cartilage surface that no image shows well. These are found by a combination of MRI, examination under anaesthesia at the time of surgery, and looking directly at the joint with an arthroscope. They matter because treating the bone and leaving a torn meniscus or an unstable ligament produces a joint that is united and still not working.
The soft-tissue assessment: what decides the day
Alongside the imaging, and independent of it, the skin and soft tissues over the joint are examined — usually daily while the patient waits. This assessment decides when the operation happens, and it is the part of the plan that patients find most surprising.
What is looked for is specific. How tense the swelling is, and whether the joint itself is distended with blood. Whether fracture blisters have formed, and whether they are filled with clear fluid or with blood — the latter indicating a deeper injury to the skin. Whether the skin wrinkles again when the limb is moved or the swelling is pressed, which is the sign that the skin has re-adhered to the layer beneath it and can be incised and closed safely. And whether there is any wound at all over the joint, however small, because a wound may mean the fracture is open.
The rule that follows is straightforward and is worth stating to every patient. An operation through skin that is still tense, blistered and shiny has a substantially higher chance of the wound failing to heal, and a deep infection around a joint whose surface has just been reconstructed is a serious and sometimes limb-changing event. So the definitive operation is deferred until the soft tissues are ready. In the interval the limb is not untreated: it is held with a splint or an external frame, elevated, and the joint is reassessed, and in most cases the waiting is measured in days.
The exceptions are absolute and they override the waiting completely. An open fracture. A dislocation that cannot be reduced, or one whose reduction has left the skin over it white and threatened. A compartment syndrome. An absent or diminished pulse. In each of these the patient goes to theatre immediately, and the operation is one of saving the soft tissues, the circulation or the limb rather than of reconstructing the joint surface — the reconstruction is deferred to a second procedure instead.
MRI, ultrasound, and the examinations that are not images
Two further investigations have specific roles, and several clinical examinations matter as much as any scan.
MRI is the image of the soft tissues inside and around the joint: the cartilage surface, the menisci of the knee, the triangular fibrocartilage of the wrist, the ligaments, and the bruising inside the bone that marks an undisplaced fracture. It is used when the radiographs do not explain the findings, when a soft-tissue injury is suspected alongside the fracture, and when the question is whether an articular fracture is present at all. It is not the planning image for bone, and it does not replace CT.
Ultrasound has a narrow but real role at the bedside: confirming a collection of fluid or blood in or around a joint, and helping to guide its aspiration. It is used for questions that are localised and answerable in a few minutes rather than for planning.
The examinations that are not images are the ones that must not be missed. The circulation distal to the joint — pulses, capillary return, temperature and colour — checked before reduction, after reduction, and at every review while the limb is swollen. The nerves — sensation and movement in the distribution beyond the joint, tested and recorded. The compartment assessment where the findings raise it: a tense, wooden-feeling compartment, pain on passive stretch of the muscles within it, and pain out of proportion to the injury; where these are present, compartment pressures are measured rather than argued about. And the skin, examined at every review as described above.
Two routine assessments complete the picture and shape the plan rather than the diagnosis: a review of the patient's medication and general fitness for anaesthesia, and an assessment of what the patient needs the joint to do — work, sport, kneeling, reaching — which sets the standard the reconstruction is aimed at.
How the plan takes shape, in what order
An assessment for this injury has a recognisable order, and patients can reasonably ask where they are in it.
The sequence runs: confirm the fracture and that it enters the joint, on radiographs in two planes. Define the joint surface with CT, and decide from it whether the surface is displaced or depressed enough to need restoring. Assess the soft tissues and decide from them whether the operation is now or later, and how the limb is held in the interval. Check the circulation, the nerves and, where indicated, the compartment pressures — and if any of those are abnormal, stop and treat them first. Plan the approach, the reduction and the implants from the CT, including whether an arthroscope will be used and whether bone graft or a substitute will be needed to support a lifted segment. And set the postoperative plan at the same time: how much movement, how much weight, and how both are advanced.
The parts worth asking about by name, because they are the parts that vary between centres and between surgeons: what the CT shows about the articular fragments; whether the operation is immediate, staged, or — in an undisplaced fracture — not an operation at all; how the limb is held in the interval; what the plan is for movement and weight-bearing afterwards; and how the joint will be followed, including what the follow-up images are looking for.
For patients who have already been treated elsewhere and are seeking a second opinion, the assessment starts from two images rather than from the report: a CT to see what the joint surface looks like now, and a weight-bearing radiograph to see how the joint is loading. Those two images answer the question that most of these enquiries are actually about — whether the joint surface is flat enough, and whether anything can be done about it now.